Korg TMR-50 - Metronome Operations; Setting Tempo and Time Signature

19
Using the metronome
Setting the tempo and time signature
1. Press the METRONOME ON buon.
The pendulum of the metronome will appear
on the display and “ ” will
appear above.
2. Press the TEMPO p or q buon to set
the tempo.
Press and hold the TEMPO p and q
buons simultaneously for 1 second to
switch between Pendulum Step (pendulum
of a mechanical metronome) and Full Step.
If Pendulum Step is selected, “ ” will
appear on the display.
Aer selecting “PENDULUM STEP” or
“FULL STEP”, press the TEMPO p, q
buons to set the tempo. This seing is
remembered even when the power is o.
If you’ve selected “PENDULUM STEP”
Pressing the TEMPO p, q buons will switch
the tempo successively through the following
values. The value will change continuously if
you hold down the buon.
30, 32, 34, 36, 38, 40, 42, 44, 46, 48, 50, 52,
54, 56, 58, 60, 63, 66, 69, 72, 76, 80, 84, 88,
92, 96, 100, 104, 108, 112, 116, 120, 126, 132,
138, 144, 152, 160, 168, 176, 184, 192, 200,
208, 216, 224, 232, 240, 252
If you’ve selected “FULL STEP”
Pressing the TEMPO p, q buons will
increment or decrement the tempo through
the range of 30–252 in steps of one. The
value will change continuously if you hold
down the buon.
3. Press the START/STOP buon to start
the metronome.
The metronome pendulum will swing from
le to right according to the tempo and the
TAP TEMPO buon will blink according