Korg TMR-50 - Troubleshooting and Formatting; Formatting While Using USB Power; Troubleshooting Common Issues

38
indicators of the tuning guide will blink
sequentially in red.
Blinking red
When the formatting procedure is
complete, the power is turned o.
Formatting while using USB power
1. Turn o the power to the TMR-50.
2. Press and hold down the A-B/DELETE
buon and the REC buon while using
a USB cable to connect the TMR-50 to
a computer.
3. Follow the same procedure as that for
formaing while using the baeries.

Page 37 “Formatting while using
baeries”
4. When the formatting procedure is
complete, a screen instructing you to
disconnect the unit from the computer
will appear on the display.

Page 35 “Disconnecting the TMR-50 from
the computer”
5. Disconnect the TMR-50 from the computer.
Troubleshooting
 Power does not turn on.
• Could the battery symbol be blinking?
Replace the batteries. Recording is not
possible if the baery symbol is blinking.
• Make sure the baeries are inserted with
the polarities (+, -) in the correct orientation.