Korg X3 User Manual

step
4
Checking
the
ASS pedal
-
Operate the ASS
pedal connected to
the
rear panel,
and check
that the
values indicated
on the LCD
change
sDOothly.
Confirn
that the value is
127 when
the pedal is
pressed,
and
0 when the pedal
is
released.
After you
have
coHpIeted this check,
press CENTER] and
proceed
to
the
next
test.
Step 5
Checking the
damper
pedal
-
Press
the damper
pedal
connected to the
rear
panel, and
check that
the LCD
indicates ONI
then release
the
pedal and
check that
OFF is
displayed
on
the LCD.
After you
have
completed this
check,
press CENTER]
to
call up
the
menu
display.
<PREL08D>
External
Test#08
-
Take out the PCM
card
that is in
the
PCM
card slot,
and
replace it
with
the
preload card.
Then,
press
C9]
to
begin
preloading.
-
After
ending the
test
mode,
produce
a few tones
and check
that they
have been
preloaded
correctly.
The
preload
card
mentioned
above is
the card
used
at
shipment.
If
you wish
to load
your own
data, or
if
there is
no
preload
card,
switch off
the power to
forcibly
end
the test
mode
and then
switch
the
power on
again,
and load
your data
from a
floppy
disk.
*
<Floppy
Disk Drive
Test>
This test
checks the
READ.
WRITE
and
COMPARE
functions
of the
floppy
disk
drive.
-
Turn the
power
on
while
pressing
both
CENTER]
and Cl].
-
When
the
menu screen
appears,
press CO]
to
enter
the
Floppy
Disk
Drive
Test
mode.
24

Korg X3 Specifications

General

Polyphony	32 voices
Multitimbral	16 parts
Presets	200 programs, 200 combinations
User Patches	100 programs, 100 combinations
MIDI	In, Out, Thru
Weight	10.5 kg
Type	Workstation
Keyboard	61 keys
Sequencer	16-track
Display	LCD
Outputs	Stereo
Memory	Internal