kozy heat 932 Installation And Operating Manual

Other manuals for kozy heat 932

Installation And Operation Manual39 pages

Installation & Operating Manual35 pages

• M

  Miss Abigail WoodAug 8, 2025

  What to do if my Kozy Heat Indoor Fireplace burner won't light?

  

  Same questionReply

  • J

    Jonathan AvilaAug 8, 2025

    If the burner on your Kozy Heat Indoor Fireplace won't light, several factors could be the cause. First, ensure the pilot light is lit. Next, check that the regulator valve is turned "on." Also, verify the rocker switch is activated, exposing the "Red" or "on" indicator. If these steps don't work, inspect the rocker switch wire connections and the generator wires at the regulator terminals for looseness. Additionally, check for pinched generator wires. Finally, ensure that any connected wall switch, remote control, or thermostat is properly connected and set.

    

    Reply
• E

  Emily ReynoldsAug 12, 2025

  Why won't my kozy heat 932 pilot stay lit?

  

  Same questionReply

  • D

    donnachanAug 12, 2025

    If the pilot light on your Kozy Heat Indoor Fireplace won't stay lit, consider these potential causes: * Ensure you are holding the black control knob in long enough to properly heat the thermocouple. * Check the thermocouple wire connection at the valve to make sure it is secure. * Examine the pilot hood to confirm it's not misdirecting the pilot flame away from the thermocouple; the flame must burn on both the generator and thermocouple.

    

    Reply
• K

  Krista SmithAug 16, 2025

  Why won't my Kozy Heat Indoor Fireplace pilot light?

  

  Same questionReply

  • H

    higginsdebraAug 16, 2025

    If the pilot light on your Kozy Heat Indoor Fireplace won't light, check the following: First, ensure the gas supply is turned on. Next, make sure the gas line has been bled out by holding the black control knob in long enough. Finally, verify that you are holding the black control knob in long enough.

    

    Reply
• P

  Patrick MullinsAug 20, 2025

  What to do if my Kozy Heat Indoor Fireplace burner won't stay lit?

  

  Same questionReply

  • D

    Dennis WagnerAug 20, 2025

    If the burner on your Kozy Heat Indoor Fireplace won't stay lit, the issue might be related to the wall switch or thermostat wiring. If a wall switch or thermostat is connected with wire that is too thick or runs more than 30 ft, disconnect the wires from the valve. If the burner then stays lit, you should change the location or use the on/off switch only.

    

    Reply

kozy heat 932 Specifications

General

Brand	kozy heat
Model	932
Category	Indoor Fireplace
Language	English

Related product manuals

kozy heat 936

39 pages

kozy heat CSK-34 L

33 pages

kozy heat SP-34-LE

58 pages

kozy heat CSK-29-G

39 pages

kozy heat SLAYTON-60

51 pages

kozy heat SLAYTON-42S

52 pages

kozy heat Bayport-41-G

55 pages

kozy heat Nordik 48 DV

72 pages

kozy heat Delano DEL-36

49 pages

kozy heat ROOSEVELT 29 BW

39 pages

kozy heat MINNETONKA 55345

40 pages

kozy heat MPS-30 Minneapolis

39 pages