Kracht GmbH Repairs | 10
88046020002 45 / 46
10.2 General
The repairs covers:
1. Troubleshooting
Determination of damage, pinpointing and localisation of the damage cause.
2. Elimination of damage
Elimination of the primary causes and replacement or repair of defective components.
The repair is generally made by the manufacturer.
Repairs by manufacturer
Before returning the device, fill in the return notification form. The form can be filled in on-
line and is available as a pdf file download.
TIPP
Device contains hazardous material
If the device was operated with dangerous liquids, it must be cleaned before the return. If
this should not be possible, the safety data sheet of the hazardous material is to be provided
beforehand.
Repair by equipment builder/operator
If corresponding expertise and sufficient equipment is available, the equipment builder/oper-
ator can also make the repairs. Please consult the manufacturer about this.
a) If required, request spare parts lists and assembly drawings from the manufacturer.
b) Use spare parts approved by the manufacturer only
c) Dispose of packing material and used parts in accordance with the local stipulations.
NOTICE
Warranty
Any warranty will be void if not executed properly.
NOTICE
Protective equipment and notices
After maintenance and/or repair, reattach all protective devices and notices removed in the
process to their original position.
To Next Page
Loading...
Need help?
General
