22
5. Connect waterlines
· Connect waterlines (5A&B) to angle stops. Tighten both ends of
waterlines with a wrench until snug. Turn on hot and cold angle
stops and check for leaks.
6. Flush spray hose
· Remove spray head (1) from spray hose (6). Hold tip of spray hose
(6). Turn faucet on and let the water run for 60 seconds to flush any
debris.
NOTE: Please make sure washer (7) is installed attaching spray head to hose
7. Check for leaks
· Check for leaks at the connections. Retighten if necessary.
To Next Page
Loading...
