9
7
Drive the Screws
a. Place a screw on the driver bit (G).
b. Position the screw in the pilot hole.
c. Drive the screw until fully seated without over driving the screw.
G
G
Set-Up and Screw Length Chart For Kreg Screws
Material
Thickness
Easy-Set
Stop Collar
Material Thickness
Stop
Screw
Length
1/2" 1/2" 1/2" 3/4" (19 mm)
3/4" 3/4" 3/4" 1-1/4" (32 mm)
Note Use only SPS style head screws.
Note The recommended screw length is 3/4" (19 mm), but in some slightly
thicker materials a 1" (25 mm) screw could be used for increased holding
power.
To learn more about selecting and purchasing Kreg Screws,
visit: www.kregtool.com/screws.
To Next Page
Loading...
