To Next PageTo Next Page
Need help?Do you have a question about the Kreg R3-INT and is the answer not in the manual?
Warning about chemicals known to cause cancer and reproductive harm.
Read manual, wear PPE, handle with care, secure workpiece, avoid impairment.
Warning about hazardous dust from construction activities.
Manual guides jig adjustment and pocket hole drilling; lists helpful resources.
Links to social media, community, and newsletter for project inspiration.
Adapter for Kreg face clamps, turns clamp and jig into one assembly.
Two-hole guide for straight drilling; hardened steel guides.
Sliders adjusted by thumb to set jig for different workpiece thicknesses.
Holes allowing wood chips to escape for faster drilling and tool longevity.
Hole for securing jig to workpiece with a screw in tight locations.
Key-hole slots for tool-less attachment of clamp pad adapter.
Used to set drilling depth by positioning on drill-bit shank.
Special drill bit for pocket holes and pilot holes; driver bit for clearance.
Slide stop collar on drill bit; align collar with workpiece thickness mark.
Adjust sliders to match workpiece thickness for correct screw exit.
Use chart to select screw length and jig slider setting based on material thickness.
Recommended for softwoods and composites due to large diameter and thread pitch.
Recommended for hardwoods to reduce material splitting.
Position jig, secure with clamp or screw; alternative for inside cabinets.
Align bit, set depth, drill at full speed, clear chips, stop when collar contacts guide.
Warning about chemicals known to cause cancer and reproductive harm.
Read manual, wear PPE, handle with care, secure workpiece, avoid impairment.
Warning about hazardous dust from construction activities.
Manual guides jig adjustment and pocket hole drilling; lists helpful resources.
Links to social media, community, and newsletter for project inspiration.
Adapter for Kreg face clamps, turns clamp and jig into one assembly.
Two-hole guide for straight drilling; hardened steel guides.
Sliders adjusted by thumb to set jig for different workpiece thicknesses.
Holes allowing wood chips to escape for faster drilling and tool longevity.
Hole for securing jig to workpiece with a screw in tight locations.
Key-hole slots for tool-less attachment of clamp pad adapter.
Used to set drilling depth by positioning on drill-bit shank.
Special drill bit for pocket holes and pilot holes; driver bit for clearance.
Slide stop collar on drill bit; align collar with workpiece thickness mark.
Adjust sliders to match workpiece thickness for correct screw exit.
Use chart to select screw length and jig slider setting based on material thickness.
Recommended for softwoods and composites due to large diameter and thread pitch.
Recommended for hardwoods to reduce material splitting.
Position jig, secure with clamp or screw; alternative for inside cabinets.
Align bit, set depth, drill at full speed, clear chips, stop when collar contacts guide.
General| Type | Pocket Hole Jig |
|---|---|
| Model | R3-INT |
| Drill Bit Size | 3/8 inch |
| Drill Bit Diameter | 3/8 inch |
| Joint Thickness Capacity | 1/2 inch to 1-1/2 inch |
| Included Components | Depth Collar, Allen Wrench |
