To Next PageTo Next Page
Need help?Do you have a question about the Kreg r3 and is the answer not in the manual?
General| Type | Pocket Hole Jig |
|---|---|
| Clamping Method | Toggle clamp |
| Adjustable Depth | Yes |
| Drill Bit Size | 3/8 inch |
| Wood Thickness Capacity | 1/2 inch to 1-1/2 inch |
| Pocket Hole Size | 3/8 inch |
| Includes | Stepped Drill Bit, Depth Collar, Allen Wrench, Screws |
| Material | Plastic |
| Screw Sizes | #6, #7, #8, #9 |
Measure workpiece thickness and adjust jig sliders to match for correct pocket hole placement.
Set depth collar on drill bit using the case scale for correct pocket hole depth.
Securely clamp the jig to the workpiece and drill until the depth collar contacts the jig body.
Align workpieces, clamp them, and drive screws with the square driver bit.
Adjust sliders on the jig body to align with material thickness for correct pocket hole location.
Position the depth collar on the drill bit using the case scale or a ruler for proper hole depth.
