KRESS KG760 Series User Manual (English)

Questions and Answers:

C
Catherine ByrdAug 7, 2025
What to do if KRESS Lawn Mower motor stops while mowing?
- A
  Allen ThompsonAug 7, 2025
  If the motor stops while mowing, release the Operating Bail to turn the mower off and remove the batteries. Check if the mower is plugged with grass debris and remove any debris from the blade rotation area. Ensure the battery is fully charged by plugging in the charger and waiting for the green light. Avoid overloading the mower by slowing down the cutting pace or raising the cut height, or both. You can also try raising the cutting height of the wheels to the highest position and starting the mower.
B
Brittany MaxwellAug 13, 2025
Why KRESS KG760 doesn’t run when Operating Bail is activated?
- A
  Andrew ReillyAug 13, 2025
  If the mower doesn’t run when the Operating Bail is activated, check to make sure the Safety lock-out button is being completely pushed. Also, release the Operating Bail to turn the mower off, remove the batteries, turn the mower over, and check that the blade is free to turn. If it's not free, return it to an authorized servicer, as the blade should turn freely. Ensure the battery has been fully charged by plugging in the charger and waiting for the green light. For starting, press both the Safety lock-out button and the Operating bail at the same time.
R
Rebecca LoweAug 18, 2025
Why KRESS KG760 runs but cutting performance is unsatisfactory?
- A
  Angela FordAug 19, 2025
  If the mower runs but the cutting performance is unsatisfactory, ensure the battery has been fully charged by plugging in the charger and waiting for the green light. Release the Operating Bail to turn the mower off and remove the batteries. Turn the mower over and check the blade for sharpness, keeping it sharp. Also, inspect the deck and discharge chute for clogging. The wheel height adjustment may be set too low for the grass condition, so try raising the cutting height.
E
Emily TurnerAug 25, 2025
What to do if KRESS KG760 is abnormally noisy and vibrates?
- M
  Matthew DuffyAug 25, 2025
  If the mower is abnormally noisy and vibrates, release the Operating Bail to turn the mower off and remove the batteries. Turn the mower on its side and check the blade to ensure it has not been bent or damaged. If the blade is damaged, replace it with a replacement blade. If there is no visible damage to the blade and the mower still vibrates, release the Operating Bail to turn the mower off, remove the batteries, and remove the blade. Rotate the blade 180 degrees and retighten. If the mower still vibrates, return it to an authorized service center.
J
Jonathan MeyerAug 31, 2025
How to fix a KRESS KG760 that is too hard to push?
- B
  Benjamin CortezAug 31, 2025
  If the mower is too hard to push, raise the cutting height to reduce deck drag on the grass. Also, check each wheel for free rotation.