KRESS MISSION KR133E User Manual (English)

Questions and Answers:

S
Stephanie RobinsonAug 17, 2025
What to do if my KRESS MISSION KR133E Lawn Mower MissionTM runs outside the boundary wire?
- S
  shawn66Aug 17, 2025
  If your KRESS Lawn Mower MissionTM runs outside the boundary wire, or doesn't mow within a boundary wire zone, or reverses/rotates erratically near the boundary wire, consider these potential causes and solutions: * Ensure your MissionTM boundary wire has at least 1m of spacing between any neighboring boundary wire. * Check that the boundary wire doesn't have acute angles and ensure the angles are smooth. * Inspect boundary wire joints and insulate to provide a fully waterproof connection, especially in wet conditions where the electric signal may leak. * Repair damaged boundary wire insulation with insulation tape. * Decrease the cutting area if it is larger than the allowable cutting area for MissionTM.
R
Randy AndersonAug 20, 2025
What to do if my KRESS MISSION KR133E MissionTM cannot correctly dock with the Charging station?
- J
  Jason RodriguezAug 20, 2025
  If your KRESS Lawn Mower MissionTM is having trouble docking with the charging station: 1. Try restarting MissionTM, as environmental influences may be interfering. 2. Clean the contact pins on both the charging station and the charging strip on MissionTM with a cloth to remove any debris that may be causing a poor connection.
J
Jonathan BarkerAug 22, 2025
What to do if my KRESS Lawn Mower MissionTM still works when it is outside the Geo fence?
- A
  arobertsAug 23, 2025
  If your KRESS Lawn Mower MissionTM continues to operate even when it's outside the Geo fence, it's likely that the Geo Fence hasn't been set up properly, or the radius of the Geo Fence hasn't been defined. Use the MissionTM App to set it correctly.
D
dennischarlesAug 26, 2025
What to do if my KRESS Lawn Mower MissionTM does not give an alarm when it is outside the Geo fence?
- J
  Joshua RasmussenAug 26, 2025
  If your KRESS Lawn Mower MissionTM isn't alarming when outside the Geo fence, consider these possibilities: * Update the software of MissionTM to the latest version before using the GeoTrace feature. * Ensure MissionTM is outside the tolerance area (approximately 30m from the Geo fence) to verify GeoTrace is working. * Turn on MissionTM and recharge if necessary. The GeoTrace will be recharged by the MissionTM battery. Note that GeoTrace has an inner battery that lasts a week after the machine is turned off. * Use the MissionTM App to properly set the Geo Fence and its radius. * If MissionTM is powered off, the alarm will be sent 10 minutes after it's taken outside the Geo fence.
M
Matthew BeardAug 28, 2025
Why is the LED light on the KRESS MISSION KR133E charging station not turning on?
- D
  Diane HaynesAug 28, 2025
  If the LED light on the KRESS Lawn Mower charging station isn't turning on, it could be due to a lack of power. Check that the charging station is properly connected to the charger, and that the charger is connected to a suitable power supply.
B
Barry TurnerAug 31, 2025
What to do if my KRESS Lawn Mower MissionTM works normally but the communication between MissionTM and smartphone does not work properly?
- C
  Charles CurryAug 31, 2025
  If your KRESS Lawn Mower MissionTM is functioning correctly, but communication between MissionTM and your smartphone is not working, consider the following: * Check the cellular network coverage of GeoTrace. If the signal is weak, move to an area with a good signal. * Update the software of MissionTM. * Update your MissionTM App. * Before first use, ensure you have activated the SIM by following the procedure in the App. * Check that the GeoTrace connector is correctly inserted with a click by contacting a dealer. * Check if the screen of MissionTM is illuminated. If not, send MissionTM back to the charging base for charging or start emergency procedure to charge it. * Once expired the SIM subscription fee must be renewed.
J
justingomezSep 2, 2025
Why does the KRESS MISSION KR133E MissionTM exit the boundary wire when going down a hill?
- A
  Annette EstradaSep 3, 2025
  The KRESS Lawn Mower MissionTM might exit the boundary wire when going downhill if the boundary wire is placed on a slope steeper than 17% (10°). Reposition the boundary wire away from slopes exceeding this steepness.
E
Emily JohnstonSep 5, 2025
Why does the red light turn on the KRESS MISSION KR133E Lawn Mower charging station?
- M
  myerskellySep 5, 2025
  The red light on the KRESS Lawn Mower charging station indicates that the boundary wire isn’t connected. Verify that the boundary wire is correctly connected to the charging station and that there are no breaks in the wire, especially at the ends.
R
Renee FosterSep 8, 2025
How to fix KRESS Lawn Mower MissionTM displaying 'outside working area' inside its working area?
- T
  timothy49Sep 8, 2025
  If your KRESS Lawn Mower MissionTM displays “outside working area” while inside its working area and the LED is green, it means the boundary wire ends are clamped incorrectly. Reverse the boundary wire ends to correct this.
B
brianberrySep 12, 2025
Why is my KRESS MISSION KR133E MissionTM unable to achieve real time positioning?
- M
  martinezjamesSep 12, 2025
  If your KRESS Lawn Mower MissionTM cannot achieve real-time positioning, it may be because the GeoTrace is designed to update the positioning every 10 minutes for power economy. When MissionTM has low battery capacity, the time interval of positioning update will be longer. This is normal, and no action is needed.

KRESS MISSION KR133E Specifications

General

Power Source	Battery
Cutting Width	33 cm
Battery Voltage	20 V
Weight	9.2 kg
Engine Type	Brushless

Summary

Product Safety

General Safety Warnings

Crucial safety instructions to prevent electric shock, fire, and injury during operation.

Safe Operation Practices

Guidelines for safe use, operator familiarity with controls, and operator responsibility.

Preparation Steps

Pre-operation checks including boundary wire installation and blade inspection for damage.

General Operation Rules

Rules for mower operation, keeping clear of moving parts, and prohibiting unauthorized modifications.

Additional Operation Precautions

Safety measures for automatic operation, considering the presence of pets, children, or people.

Maintenance and Storage Guidelines

Procedures to maintain safe working condition and proper storage of the appliance.

Battery Pack Safety

Critical warnings and handling instructions for battery packs to prevent hazards.

Symbols

Warning Symbols Overview

Interpretation of various warning symbols related to product usage and safety precautions.

Product and Disposal Symbols

Explanation of symbols for appliance class, electrical waste disposal, and cleaning methods.

Component Identification

Mower Parts Identification

An illustrated list identifying the main components of the robotic lawnmower.

Charging and Accessory Components

Identification of the power adapter, charging base, boundary wire gauge, and hex key.

Technical Specifications

Mower Technical Data

Detailed technical specifications for KR133E and KR136E robotic lawnmower models.

GeoTrace Technical Data

Technical specifications for the GeoTrace feature, including operating and storage parameters.

Noise Level Information

Data on sound pressure and power levels, with recommendations for hearing protection.

Recommended Accessories List

List of genuine accessories recommended for purchase with the lawnmower.

Operation and Maintenance

Intended Use of the Product

Defines the primary purpose of the robotic lawnmower as efficient lawn mowing.

Blade Maintenance and Replacement

Instructions for keeping blades sharp, replacing them, and ensuring proper balance.

Cleaning Procedures

Guidelines for cleaning the mower's body, underside, and charging contacts.

Battery Life and Winter Storage

Information on battery lifespan, charging, and recommended winter hibernation practices.

Battery Replacement Guide

Step-by-step instructions for safely removing and replacing the mower's battery.

Troubleshooting

General Troubleshooting Guide

Common operational issues, their causes, and corresponding solutions for the mower.

GeoFence and Connectivity Issues

Troubleshooting for GeoFence alarms, location tracking, and smartphone app communication problems.

Declaration of Conformity

Product Compliance and Directives

Details the product's compliance with relevant EU directives and legislation.

Notified Bodies and Standards

Lists involved notified bodies and applicable conformity standards for the product.

Related product manuals

KRESS MISSION KR161

48 pages

KRESS Mission RTKn 5000