4 Operating Instructions
The chiller may only be transported in original packaging to the site of initial operation. In case of damage
the manufacturer must be informed immediately. If the unit is moved to another location in a factory, all
connections must be disconnected from the unit. Moving the unit to another location must be carried out
without causing damages. If damage occurs despite these instructions, the unit must be checked by an
expert and repaired as required before it is put into operation again.
Note:
The Manufacturers Liability excludes any Damage to the Chiller
subsequent to Transportation.
When transporting the unit, consider the weight limits indicated in the technical data.
Use a fork-lift, truck or a crane with the corresponding load-capacity.
The fully-hermetic compressor is mounted on rubber. Always transport the chiller as
mentioned below. Avoid vibrations during transport. Failure to observe can result in
compressor damage.
Instructions during transport!
Attention: Never remove the top cover if transporting the chiller
by means of a hoist (via eyelets)!
Wrong Right
2 TRANSPORT
To Next Page
Loading...
