6 Commissioning/Start-up/Shutdown
15 of 24
Controlmatic E.2
NOTE
The shut-off head of the pump must be 0.7bar higher than the pressure set at the
automatic control unit.
6.3 Shutdown/storage/preservation
▪ Pull the pump plug.
▪ Remove the automatic control unit from the piping.
▪ Rinse off with clean water.
▪ Press in the check valve at the automatic control unit and shake water out of the
automatic control unit.
▪ Leave the automatic control unit to dry and store in a dry, dark and frost-proof
room.
▪ Special preservation measures are not required.
6.4 Returning to service
For returning the equipment to service, observe the items on commissioning/start-up.
To Next Page
Loading...
