Installation and Operation Manual 40
8. Installation
8.1 Overview
The installation introduction of KSG-10K/12K/15K/17K/20K
inverter is as follows. Please read this chapter carefully to help you
install the KSG-10K/12K/15K/17K/20K photovoltaic grid- connected
inverter correctly.
Inspection of damage during transportation
The KSG-10K/12K/15K/17K/20K inverter may be damaged during
transportation even if we have conducted the test and detection for
it before transportation. Therefore, please inspect it before
installation. If any damage is detected, please contact with the
transportation company or our company directly. We will provide
you with the best and quickest service after you provide the photo of
damaged part.
Basic installation requirement
The KSG-10K/12K/15K/17K/20K inverter can be installed
outdoors with water-proof and dust-proof level of IP65. Some
basic installation requirements are as follows:
It is the best to install it in the place where it is away from the
living area due to some noise produced during its operation
(<40dB).
Assure there is no shake in the installation place.
Assure that the LED light or LCD can be observed conveniently
installation place.
Assure that the ambient temperature is of -25°C ~ +60°C.
Good ventilation is required.
Clean installation environment is required.
To Next Page
Loading...
Need help?
General
