What to do if KStar Inverter DC current is high?
If the KStar Inverter displays a 'Inverter DC Current High' error, follow these steps: 1. Disconnect the PV input and restart the inverter after a few minutes to see if the fault still exists. 2. If the fault persists, contact your local distributor.
What to do if KStar Inverter inverter current is high?
If the KStar Inverter displays a 'Inverter Current High' error, follow these steps: 1. Disconnect the PV input and restart the inverter after a few minutes to see if the fault still exists. 2. If the fault persists, contact your local distributor.
What to do if KStar Inverter hardware current is high?
If the KStar Inverter displays a 'Hardware Current High' error, follow these steps: 1. Disconnect the PV input and restart the inverter after a few minutes to see if the fault still exists. 2. If the fault persists, contact your local distributor.
What to do if KStar Inverter leakage current is high?
If the KStar Inverter displays a 'Leakage Current High' error, follow these steps: 1. Disconnect the PV input and restart the inverter to see if the fault still exists. 2. If the fault persists, contact your local distributor.
What to do if KStar KSG-3.2K-DM input current is high?
If the KStar Inverter shows an input current high error, follow these steps: 1. Check the setting of input mode. 2. Disconnect the PV input and restart the inverter to see if the fault still exists. 3. If the fault persists, contact your local distributor.
What to do if KStar KSG-3.2K-DM Inverter shows amb temperatur over?
If your KStar Inverter displays an 'Amb Temperatur Over' error, follow these steps: 1. Disconnect the PV input and allow the inverter to cool down. Then, restart it to see if it returns to normal operation. 2. Check the environmental temperature to ensure it is within the specified working range. 3. If the fault persists, contact your local distributor.
What to do if KStar KSG-3.2K-DM Inverter bus voltage is too high or too low?
If the KStar Inverter indicates that the bus voltage is too high or too low, follow these steps: 1. Check the setting of input mode. 2. Disconnect the PV input and restart the inverter to see if the fault still exists. 3. If the fault persists, contact your local distributor.
How to fix system faulty or failure type on KStar KSG-3.2K-DM?
If the KStar Inverter shows a system faulty or failure type error, it might be due to the AC voltage and frequency being too high or too low. Here are some steps to take: 1. Check if the mains voltage complies with local safety standards. 2. Ensure the AC output line is properly connected and check its output voltage to see if it is normal. 3. Disconnect the PV input and restart the inverter to see if the fault still exists. 4. If the fault persists, contact your local distributor.
Why is my KStar KSG-3.2K-DM Inverter on remote off status?
Guidelines for selecting a suitable site and mounting the inverter.
Specifies the correct orientation and height for inverter installation.
Step-by-step instructions for mounting the inverter on a wall.
Details the connection ports and wiring requirements for the inverter.
Outlines the steps for connecting to the grid and solar array.
To Next Page
General
