KTI Networks KGS-1060 User Manual

KGS-1060
KGS-1060-HP
Industrial Managed
10-Port Gigabit Ethernet Switches
with 2 Dual-speed SFP Slots and 4 PoE PSE Ports
Firmware Rev1.05 up
User’s Manual
DOC.150608
-1-

KTI Networks KGS-1060 Specifications

General

Switching Capacity	120 Gbps
Forwarding Rate	89.28 Mpps
MAC Address Table Size	8K
Power Consumption	45W
Jumbo Frame Support	9KB
Power Input	100~240VAC, 50/60Hz
Operating Temperature	0°C ~ 40°C
Ports	10/100/1000BASE-T

Summary

1. Introduction

1.1 Features

Lists the key capabilities and functionalities of the KGS-1060 series managed Gigabit Ethernet switches.

1.4 Specifications

Details the technical specifications for the 10/100/1000 Copper Ports and Dual-speed SFP Slots.

2. Installation

2.5 Applying Power

Explains how to connect the power supply via terminal block, including DC input voltage specifications.

2.6 Alarm Relay Output

Describes the alarm relay output functionality for reporting failure events to a monitoring system.

2.7 Powered via PoE over Cat.5

2.9 Making UTP Connections

2.10 Making Fiber Connection

2.11 Making PoE PSE Connections

2.13 Making Console Connection

3. Manage the Switch

3.1 IP Address & Password

3.2 Configuring IP Address & Password via console and telnet

Explains how to set IP addresses and passwords using CLI commands via console or telnet interfaces.

3.3 Configuring IP Address via Web Interface

Details the process of configuring the switch's IP address, subnet mask, and gateway via the web interface.

3.5 Configuration for SNMP Management

Explains how to configure SNMP settings, including version, community, and trap settings, via telnet or web interface.