ENGLISH
38
Check/set distance of the magnetic sensor
The distance between the magnet 2 and the sensor 1 must be 2-4 mm,
otherwise malfunctions on the speedometer might occur.
This distance can be corrected by screwing the sensor
1 in or off.
mm x 3,14
KMH:
WS = mm x 3.14
MPH:
WS = (mm x 3.14) : 1.61
1
2
Wheel circumference with standard tires = 2205 mm
Replacing the headlight lamp/parking light lamp
Loosen both rubber bands and tilt the headlight mask to the front. Pull the
parking light lamp with holder
3 carefully out of the reflector. Pull
connector
4 off the headlamp and remove rubber cap 5. Disengage retai-
ning clip and take the bulb out of the reflector. When changing the par-
king-light lamp, simply pull it out of the holder.
Insert a new lamp such that the noses
6 engage in the recesses 7 .When
doing so, do not touch the glass body of the lamp so that it remains free
from fat. Engage retaining clip, mount rubber cap and connector. If the par-
king-light lamp is to be replaced, simply insert it in the holder. Reinsert par-
king-light lamp together with the holder.
Engage the bottom end of the headlamp mask at the retaining pins and fix
the mask by means of the rubber bands.
1
3
4
5
6
7
To Next Page
Loading...
