EasyManua.ls Logo

KTM 125 - Transmission Oil Management (125;200 cc); Checking Transmission Oil Level (125;200 cc); Changing Transmission Oil (125;200 cc); Transmission Oil Management (250;300 cc)

KTM 125
67 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
44
Check transmission oil level (125/200)
In order to check the transmission oil level the control screw 1 on the clutch
cover is to be removed. Oil should just barely escape from the inspection
opening when the motorcycle is in an upright position. If necessary, remove
the plug
2 and top up with oil (see technical data engine).
!
CAUTION
!
T
RANSMISSION AND CLUTCH WILL BE SUBJECTED TO EXCESSIVE WEAR AND TEAR IF YOU USE
TOO LITTLE OR LOW GRADE OIL
. USE ONLY HIGH-GRADE OIL.
Changing the transmission oil (125/200) *
To change the gear oil warm up the engine and park the motorcycle on a
horizontal surface. Remove oil drain plugs
3 and 4 and drain the used oil
into an appropriate container. Clean the magnets of the oil drain plugs and
mount them together with the appropriate gaskets. Fill in 0.7 l oil (see tech-
nical data- engine), mount the plug
2 and check the engine for leaks.
!
CAUTION
!
T
RANSMISSION AND CLUTCH WILL BE SUBJECTED TO EXCESSIVE WEAR AND TEAR IF YOU USE
TOO LITTLE OR LOW GRADE OIL
. USE ONLY HIGH-GRADE OIL.
Check transmission oil level (250/300)
In order to check the transmission oil level the control screw 5 on the clutch
cover is to be removed. Oil should just barely escape from the inspection
opening when the motorcycle is in an upright position. If necessary, remove
the plug
6 and top up with oil (see technical data- engine).
!
CAUTION
!
T
RANSMISSION AND CLUTCH WILL BE SUBJECTED TO EXCESSIVE WEAR AND TEAR IF YOU USE
TOO LITTLE OR LOW GRADE OIL
. USE ONLY HIGH-GRADE OIL.
Changing the transmission oil (250/300) *
To change the transmission oil run the engine warm and set up the motorcy-
cle on a horizontal surface. Remove the oil drain screw
7 and drain used oil
into a container. Clean the magnet of the oil drain screw and reinstall oil
drain screw with seal. Pour in 0.8 litres engine oil (see technical data engine),
replace plug
6 and check engine for leaks.
!
CAUTION
!
T
RANSMISSION AND CLUTCH WILL BE SUBJECT TO EXCESSIVE WEAR AND TEAR, IF YOU USE
TOO LITTLE OR LOW GRADE OIL
. USE ONLY HIGH-GRADE OIL.
1
2
3
4
5
6
7

Other manuals for KTM 125

Related product manuals