SERVICE SCHEDULE (SX‑F) 38
11.2Important maintenance work to be carried out by an authorized KTM workshop (as additional order)
S10A S20N S20A S30A S40A S80A J1A
Conduct a major fork service. (SX‑F) x
•
Conduct a minor fork service. (SX‑F) x
• • • • •
Perform a shock absorber service. (SX‑F) x
• • •
Grease the steering head bearing. x
•
Treat electric contacts with contact spray. •
Change the hydraulic clutch fluid. x ( p. 83)
•
Change the front brake fluid. x
•
Change the rear brake fluid. x
•
Check the clutch discs for wear. x
• • •
Check the clutch. x
• • •
Check the cylinder and piston for wear. x
• •
Check the camshafts. x
• •
Check the valve spring seat. x
• •
Check the valves. x
• •
Change the valves. x
•
Check wear of valve guides. •
Change the valve springs. x
• •
Check the timing-chain tensioner function. x
• •
Check the crankshaft run-out at the bearing pin. x
• •
Change the conrod bearing. x
• •
Change the crankshaft main bearing. x
•
Fully check the transmission. x
• •
Check the shift mechanism. x
• •
Check the spring length of the oil pressure regulator valve. x
• •
Change the glass fiber yarn filling of the main silencer. x
• • • • •
Change the foot brake cylinder seals. x
• • •
Check/adjust the carburetor components. x
• • •
S10A: Every 10 service hours - corresponds to about 70 liters of fuel (18.5 US gal) / after every race
S20N: Once after 20 service hours - corresponds to about 140 liters of fuel (37 US gal)
S20A: Every 20 service hours - corresponds to about 140 liters of fuel (37 US gal)
S30A: Every 30 service hours - corresponds to about 210 liters of fuel (55.5 US gal)
S40A: Every 40 service hours - corresponds to about 280 liters of fuel (74 US gal)
S80A: Every 80 service hours - corresponds to about 560 liters of fuel (148 US gal)
J1A: annually
To Next Page
Loading...
Need help?
General
