21 TROUBLESHOOTING
148
Faults Possible cause Action
Engine has too little power Air filter very dirty – Clean the air filter and air filter box.
( p. 78)
Exhaust system leaky,
deformed or too little glass
fiber yarn filling in main
silencer
– Check exhaust system for damage.
– Change glass fiber yarn filling in the
main silencer. ( p. 80)
Fault in ignition system – Check the ignition system.
Diaphragm or reed valve hous-
ing damaged
– Check the diaphragm and reed valve
housing.
Engine stalls or is popping into
the carburetor
Lack of fuel –
Turn handle
1
of the
fuel tap to the ON position.
(Figure E00826-10 p. 21)
– Refuel. ( p. 48)
Engine takes in bad air – Check the intake flange and carburetor
for tightness.
The connector or ignition coil is
loose or oxidized
– Clean the connector and treat it with
contact spray.
Engine overheats Too little coolant in cooling sys-
tem
– Check the cooling system for leakage.
– Check the coolant level. ( p. 126)
Too little air stream – Switch off engine when stationary.
Radiator fins very dirty – Clean the radiator fins.
Foam formation in cooling sys-
tem
– Drain the coolant. ( p. 126)
– Refill with coolant. ( p. 127)
Damaged cylinder head or
cylinder head gasket
– Check the cylinder head and cylinder
head gasket.
Bent radiator hose – Change the radiator hose.
Incorrect ignition point due to
loose stator
White smoke emission (steam
in exhaust gas)
Damaged cylinder head or
cylinder head gasket
– Check the cylinder head and cylinder
head gasket.
Gear oil exits at the vent hose Too much gear oil added – Check the gear oil level. ( p. 140)
Water in the gear oil Damaged shaft seal ring or
water pump
– Check the shaft seal ring and water
pump.
To Next Page
Loading...
Need help?
General
