2 SETUP
4
Info
Make sure the cables and wiring are positioned cor-
rectly.
– Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
M8 20 Nm (14.8 lbf ft)
Info
The markings on the handlebar should be at the center
of the handlebar clamps.
Keep the installed gap widths equal when tightening.
F02440-10
– Position the handlebar cushion and secure with a cable tie.
– Remove the fuel tank. ( p. 9)
F02441-10
– Mount the service hour counter on the holder.
–
Feed the service hour counter cable through the recess
A
and route it under the wiring harness
3
along the frame to
the ignition wire.
Tip
Detach cable holder in the area
B
.
To Next Page
Loading...
