ENGLISH
55
TECHNICAL SPECIFICATIONS - CHASSIS
»
TIGHTENING TORQUES - CHASSIS
Collar nut front axle SXC M16x1,5 40 Nm
Collar nut front axle SMC M24x1,5 40 Nm
Collar nut rear axle M20x1.5 80 Nm
Shock absorber top M10 (10.9) 45 Nm
Shock absorber bottom M10 (10.9) 45 Nm
Collar screws brake disk rear M6 (10.9) Loctite 243 + 14 Nm
Collar screws brake disk front M6 (10.9) Loctite 243 + 14 Nm
Screw brake caliper front M8 Loctite 243 + 25 Nm
Allan head screw brake caliper front SMC M10 Loctite 243 + 40 Nm
Bearing bolt linkage arm/frame M12 60 Nm
Collar nuts rocker arm bolts M14x1.75 100 Nm
Engine mounting screw M10 45 Nm
Ball joint for push rod M8 Loctite 243 + 25 Nm
Sprocket screws on nuts M8 Loctite 243 + 35 Nm
Collar nut swingarm bolt M14x1.5 100 Nm
Clamping screws top triple clamp M8 20 Nm
Clamping screws bottom triple clamp M8 15 Nm
Clamping screws fork stubs M8 15 Nm
Screws handlebar clamp M8 20 Nm
Allan head screw handle bar support M10 Loctite 243 + 40 Nm
Spoke nipple M4.5 5 Nm
Other screws / collar nuts on chassis M6
M8
M10
10 Nm / 15 Nm
25 Nm / 30 Nm
45 Nm / 50 Nm
To Next Page
