3 WORK 9
S00622-10
–
Disconnect negative cable
3
from the battery.
–
Take off positive terminal cover
4
.
S00620-10
–
Disconnect ABS connection cable
5
and positive cable
6
from the battery.
S00621-10
–
Remove screws
7
.
–
Pull retaining bracket
8
of the battery forward and remove it.
– Lift the battery up and out.
Info
Never operate the motorcycle with a discharged battery or without a battery.
In both cases, electrical components and safety devices can be damaged.
The vehicle will therefore no longer be roadworthy.
3.5 Installing the battery
S00621-11
Main work
– Insert the battery into the battery compartment with the terminals facing rearward.
Battery (YTZ10S)
–
Position retaining bracket
1
and mount and tighten screws
2
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
S00623-10
–
Position washer
3
, positive cable
4
, and ABS connection cable
5
.
–
Mount and tighten screw
6
.
Guideline
Screw, battery terminal M6 4.5 Nm
(3.32 lbf ft)
S00622-11
–
Position positive terminal cover
7
.
–
Position washer
8
and negative cable
9
, and mount and tighten the screw.
Guideline
Screw, battery terminal M6 4.5 Nm
(3.32 lbf ft)
To Next Page
Loading...
