2 SETUP 3
2.1 Unpacking and setting up the vehicle
S01530-10
– Remove the straps and box.
S01531-10
– Remove the adhesive tape in the upper area of the motorcycle.
S01532-10
– Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking, leave the other films
on the vehicle until you have finished work on the vehicle.
– Remove the separate enclosure and unpack it. Check the separate enclosure for
completeness.
– Check the vehicle for transport damage.
S01533-10
– Remove the screws and handlebar clamps.
S00795-10
–
Remove screw
1
of the right hand guard.
S00796-10
– Position the controls on the right half of the handlebar.
Info
The figure shows how to route the cable and lines.
– Mount the screws.
To Next Page
Loading...
