MAINTENANCE WORK ON FRAME AND ENGINE 145
– Switch off the ignition by turning the orange programming key to the OFF position .
– Pull out the programming key.
– Insert the black ignition key in the ignition lock.
– Switch on the ignition by turning the black ignition key to the position ON
.
FI Warning lamp (MIL) lights up, switches off, and then starts to flash.
Immobilizer indicator lamp lights up, switches off briefly, and lights up
again.
– Switch off the ignition by turning the black ignition key to the position OFF
.
– Remove the black ignition key.
– To activate further ignition keys, repeat the last 4 steps with the respective ignition
key.
– Insert the orange programming key in the ignition lock.
– Switch on the ignition by turning the orange programming key to the ON position
.
FI Warning lamp (MIL) lights up, switches off, and then starts to flash.
Immobilizer indicator lamp lights up, switches off briefly and flashes; the
number of flashes equals the number of functional black ignition keys includ-
ing the orange programming key.
– Switch off the ignition by turning the orange programming key to the OFF position .
– Pull out the programming key.
All black ignition keys are activated included in this job sequence are activated.
Removing the storage compartment and hanging it to one side x
– Remove the seat. ( p. 76)
To Next Page
Loading...
Need help?
General
