EasyManuals Logo

Kubota B2301-1 Workshop Manual

Kubota B2301-1
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
GENERAL
B2301, B2601, WSM
G-16
Checking Engine Oil Level
WARNING
To avoid personal injury:
• Be sure to stop the engine before checking the oil level.
1. Park the machine on a flat surface.
2. Check engine oil before starting the engine or 5 minutes or more
after the engine has stopped.
3. To check the oil level, draw out the dipstick, wipe it clean,
replace it, and draw it out again. Check to see that the oil level
lies between the two notches.
If the level is too low, add new oil to the prescribed level at the
oil inlet.
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
Never mix two different types of oil.
• If oil level is low, do not run engine.
9Y1211156GEG0008US0
Checking Transmission Fluid Level
1. Park the machine on a flat surface, lower the implement and
shut off engine.
2. To check the oil level, draw out the dipstick, wipe it clean,
replace it, and draw it out again. check to see that the oil level
lies within the cross hatched area.
If the level it too low, add new oil to the prescribed level at the
oil inlet.
IMPORTANT
• If oil level is low, do not run engine.
9Y1211156GEG0009US0
Checking Coolant Level
WARNING
To avoid personal injury or death:
• Do not remove radiator cap while coolant is hot. When cool,
slowly rotate cap to the first stop and allow sufficient time
for excess pressure to escape before removing the cap
completely.
1. Check to see that the coolant level is between the "FULL" and
"LOW" makes of recovery tank.
2. When the coolant level drops due to evaporation, add soft water
only up to the full level.
In case of leakage, add anti-freeze and soft water in the
specified mixing ratio up to the full level.
IMPORTANT
• If the radiator cap has to be removed, follow the caution
above and securely retighten the cap.
• Use clean, fresh soft water and anti-freeze to fill the
recovery tank.
9Y1211156GEG0010US0
(1) Oil Inlet
(2) Dipstick
A: Oil level is acceptable within this
range.
(1) Oil Inlet
(2) Dipstick
A: Oil level is acceptable within this
range.
(1) Recovery Tank A: "FULL"
B: "LOW"
KiSC issued 11, 2014 A

Table of Contents

Other manuals for Kubota B2301-1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota B2301-1 and is the answer not in the manual?

Kubota B2301-1 Specifications

General IconGeneral
BrandKubota
ModelB2301-1
CategoryTractor
LanguageEnglish

Related product manuals