Kubota D1005-E - Stopping the Engine

12 OPERATING THE ENGINE
ENGLISH
STOPPING THE ENGINE
A If equipped with a turbo-charger, allow the engine to
idle for 5 minutes before shutting it off after a full load
operation.
Failure to do so may lead to turbo-charger trouble.
[Z482-E, Z602-E, D722-E, D902-E]
[D1005-E, D1105-E, V1305-E, V1505-E, V1505-TE,
D905-EGB, D1005-EBG, D1105-EBG, V1305-EBG,
V1505-EBG]
[D1503-M-E, D1703-M-E, D1803-M-E, V2003-M-E,
V2203-M-E, V2003-M-T-E, V2403-M-E, D1503-M-DI-E,
D1703-M-DI-E, D1803-M-DI-E, V2203-M-DI-E,
V2003-M-DI-T-E, V2403-M-DI-E, V2403-M-DI-T-E
,
D1703-EBG, V2203-EBG]
1. Return the speed control lever to low
idle, and run the engine under idling
conditions.
2. Set the engine stop lever to "STOP"
position.
3. With the starter switch placed at "OFF"
position, remove the key.(Be sure to
return the stop lever as it was after
stopping the engine, and get ready for
the next starting.)
(1) Speed control lever
(2) Engine stop lever
(A) "IDLING"
(B) "OPERATION"
(C) "START"
(D) "STOP"
(1) Speed control lever
(2) Engine stop lever
(A) "IDLING"
(B) "OPERATION"
(C) "START"
(D) "STOP"
(1) Engine stop lever
(2) Speed control lever
(A) "STOP"
(B) "START"
(C) "IDLING"
(D) "OPERATION"