S.G
GENERAL
68
rnrn
STROKE
SERIES
WSM,
01
160
0
During disassembly, carefully arrange removed
parts
in
a clean area to prevent confusion later.
Screws, bolts and nuts should be replaced in their
original position
to
prevent reassembly errors.
0
When special tools are required, use Kubota's
genuine special tools. Special tools which are not
frequently used should be made according to
the
drawings provided.
0
Before disassembling or servicing live wires, make
sure to always disconnect the grounding cable
from the battery first.
0
Remove oil and dirt from parts before measuring.
0
Use
only Kubota genuine parts for parts
replacement to maintain engine performance and
to ensure safety.
Gaskets and O-rings must be replaced during
reassembly. Apply grease to new O-rings
or
oil
seals
before assembling.
0
When reassembling external or internal snap
rings, position them
so
that
the sharp edge faces
against the direction from which force
is
applied.
0
Be
sure to perform run-in the serviced or
reassembled engine.
Do
not attempt to give heavy
load at once, or serious damage may result to
the
engine.
A
CAUTION
0
Certain components used
in
this
engine (cylinder
head-gasket, exhaust gasket, etc.) contain
asbestos. Handle with care according to safety
regulation.
(1)
Grease
(2)
Force
(3)
Place
the
Sharp
Edge
against the Direction
of
Force
[A]
External Snap Ring
[It]
Internal Snap
Ring
5-3
To Next Page
Loading...
