PERIODIC SERVICE50
BReplacing Engine Oil Filter Cartridge
To avoid serious injury:
A Be sure to stop the engine and remove the key
before changing the oil and the oil filter
cartridge.
A Allow engine to cool down sufficiently; oil can
be hot and may cause burns.
1. Remove the oil filter.
2. Put a film of engine oil on the rubber seal of the new
filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
4. Tighten the filter by hand an additional 1/2 turn only.
5. After the new filter is replaced, the engine oil normally
decreases a little. Check that the engine oil does not
leak through the seal and be sure to check the oil level
on the dipstick.
6. Then, replenish the engine oil up to the prescribed
level.
A To prevent serious damage to the engine, use only a
genuine KUBOTA filter.
BChecking Radiator Hose and Clamp
Check to see if radiator hoses are properly fixed every 200
hours of operation or 6 months, whichever comes first.
1. If hose clamps are loose or water leaks, tighten clamps
securely.
2. Replace hoses and tighten hose clamps securely, if
radiator hoses are swollen, hardened or cracked.
(1) Engine oil filter cartridge
(1) Radiator core
(2) Radiator hose
To Next Page
