Kubota F2890 - Adjusting Rear Axle Pivot; Replacing Fuel Filter; Every 800 Hours; Adjusting Engine Valve Clearance

55PERIODIC SERVICE
BAdjusting Rear Axle Pivot
If the rear axle pivot pin adjustment is not correct, rear
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, tighten adjusting screw all the way,
and then loosen the screw by 1/6 turn.
Retighten the lock nut.
BReplacing Fuel Filter
Change fuel filter every 400 hours. This should be done by
your local KUBOTA Dealer.
EVERY 800 HOURS
BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.
EVERY 1500 HOURS
BChecking Fuel Injection Nozzle (Injection
Pressure)
Consult your local KUBOTA Dealer for this service.
EVERY 3000 HOURS
BChecking Injection Pump
Consult your local KUBOTA Dealer for this service.
EVERY 1 YEAR
BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Element" in "EVERY 100
HOURS" in "PERIODIC SERVICE" section.)
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
(1) Adjusting screw
(2) Lock nut