EasyManua.ls Logo

Kubota F2890 - EVERY 400 HOURS MAINTENANCE

Kubota F2890
85 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PERIODIC SERVICE52
BChecking Intake Air Line
1. Check to see that hoses and hose clamps are tight and
not damaged.
2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
EVERY 400 HOURS
BChanging Transmission Fluid
To avoid serious injury:
A Be sure to stop the engine and remove the key
before changing or checking the oil.
A Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
The fluid in the transmission case is also used for the
hydrostatic drive system.
1. To drain oil, remove the drain plug at the bottom of the
transmission case and drain oil completely into the oil
pan.
2. After draining, reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
4. After running the engine for a few minutes, stop it and
check the oil level again; add oil to the prescribed
level.
(1) Hose
(2) Clamp
Oil capacity 14 L
(1) Oil level dipstick
(2) Oil inlet
(A) Oil level is acceptable
within this range

Table of Contents

Related product manuals