81TROUBLESHOOTING
ENGLISH
BATTERY TROUBLESHOOTING
If you have any questions, contact your local KUBOTA Dealer.
MACHINE TROUBLESHOOTING
If you have any questions, contact your local KUBOTA Dealer.
Trouble Cause Remedy Preventive measure
Starter does not
function.
A Battery overused until
lights are dim.
A Charge battery sufficiently. A Charge the battery
properly.
A Battery has not been
recharged.
A Poor terminal connection. A Clean the terminal and
tighten securely.
A Keep the terminal clean
and tight.
Apply grease and treat with
anti-corrosives.
A Battery life expired. A Renew battery.
From beginning
starter does not
function, and lights
soon become dim.
A Insufficient charging. A Charge battery sufficiently. A Battery must be serviced
properly before initial use.
When viewed from
top, the top of plates
look whitish.
A Battery was used with an
insufficient amount of
electrolyte.
A Add distilled water and
charge the battery.
A Regularly check the
electrolyte level.
A Battery was used too
much without recharging.
A Charge battery sufficiently. A Charge the battery
properly.
Recharging is
impossible.
A Battery life expired. A Replace battery.
Terminals are
severely corroded
and heat up.
A Poor terminal connection. A Clean the terminal and
tighten securely.
A Keep the terminal clean
and tight.
Apply grease and treat with
anti-corrosives.
Battery electrolyte
level drops rapidly.
A There is a crack or pin
holes in the electrolytic
cells.
A Replace battery.
A Charging system trouble. A Contact your local
KUBOTA Dealer.
Trouble Cause Remedy
Machine operation is not
smooth.
A Hydrostatic transmission fluid is insufficient. A Replenish oil.
A Filter is clogged. A Replace the filter.
Machine does not move while
engine is running.
A Parking brake is on. A Release the parking brake.
A Transmission fluid level is insufficient. A Replenish oil.
Machine moves when motion
control levers are in the
"NEUTRAL LOCK" position.
(Engine is operated.)
A Hydrostatic lever linkage is not correctly
adjusted.
A Ask your dealer for hydrostatic
lever linkage adjustment or
pressure adjustment.
A Control linkage pivots are sticking. A Lubricate linkage.
To Next Page
Loading...
Need help?
General
