PERIODIC SERVICE66
ENGLISH
SERVICE AS REQUIRED
BReplacing Fuses
Replacement of the fuse
1. Open hood.
2. Remove the blown fuse.
3. Place a new fuse of the same capacity in position.
A If the new fuse happens to blow out within a short time,
contact your dealer for inspection and repair. Never
"jump" the fuse with wire or foil, or install a larger
capacity fuse than is recommended.
C Protected circuit
BChecking and Replacing Blade
To avoid personal injury:
A Be sure to stop the engine and remove the key.
A Blades may be sharp. When you handle blades,
wear heavy gloves or wrap end of blade with a
rag.
C Checking
The blade cutting edges should be kept sharp at all times.
Sharpen the cutting edges, if they resemble blade (B).
Replace the blades if they appear similar to blade (C).
(1) Fuse location
(2) Slow blow fuse
FUSE NO.
(ID LABEL)
CAPACITY
(A)
Protected circuit
(1)
20A Engine stop
15A Charge system
15A Aux. outlet
15A Main system
10A Control system
(2)
Slow blow fuse
30
Check circuit against
wrong battery connection
(A) New blade
(B) Worn blade
(C) Cracked blade
To Next Page
Loading...
Need help?
General
