SAFE OPERATION-4
ENGLISH
C Servicing
1. Before servicing, park the machine on a firm, level
surface and apply the parking brake. Remove the key
to prevent accidental start-up.
2. Allow the machine time to cool before touching the
engine, muffler, radiator, etc.
3. Always stop the engine before refueling. Avoid spills
and overfilling. Wipe up spilled fuel immediately.
4. Use extra care in handling diesel fuels. They are
flammable.
(1) Use only an approved container.
(2) Do not remove fuel cap or refuel with the engine
running. Allow engine to cool before refueling. Do
not smoke while refueling or when standing near
fuel.
(3) Do not refuel the machine indoors and always
clean up spilled fuel or oil.
(4) Do not store the machine or fuel container inside
where there is an open flame, such as in a water
heater.
(5) If the fuel tank has to be drained, this should be
done outdoors.
(6) Replace all fuel tanks and container caps
securely.
5. Do not smoke when working around battery or when
refueling. Keep all sparks and flames away from
battery and fuel tank.
A battery, especially when charging, will give off
hydrogen and oxygen gases, which can explode and
cause serious personal injury.
6. Before "JUMP STARTING" a dead battery, read and
follow all of the instructions to help protect the
alternator from damage due to extreme load changes.
(See "JUMP STARTING" in "OPERATING THE
ENGINE" section.)
Batteries contain sulfuric acid and produce explosive
gases. Follow the instructions below to prevent
personal injury.
A Wear eye and skin protection.
A Keep sparks and flame away.
A Always have adequate ventilation while charging
or using the battery.
7. Disconnect the battery's ground cable before working
on or near electric components.
8. Do not use or charge the refillable type battery if the
fluid level is below the LOWER (lower limit level) mark.
Otherwise, the battery component parts may
prematurely deteriorate, which may shorten the
battery's service life or cause an explosion. Check the
fluid level regularly and add distilled water as required
so that the fluid level is between the UPPER and
LOWER levels.
9. Keep first aid kit and fire extinguisher handy at all
times.
10.Do not remove the radiator cap while coolant is hot.
When cool, slowly rotate cap to the first stop and allow
sufficient time for excess pressure to escape before
removing the cap completely. If the machine has a
coolant recovery tank, add coolant there instead of the
radiator.
11.Do not attempt to mount a tire on a rim unless qualified
to do so and all proper safety precautions are followed.
12.Always maintain the correct tire inflation pressure. Do
not inflate tires above the recommended pressure
shown in the Operator's Manual.
13.Provide adequate support when changing wheels.
14.Make sure that wheel nuts and bolts have been
tightened to the specified torque.
6. SERVICING AND STORAGE
(1) Fuel tank cap