EasyManuals Logo

Kubota LX3310 User Manual

Kubota LX3310
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #118 background imageLoading...
Page #118 background image
12. Checking gauges, meter and
Easy Checker
â„¢
1. Inspect
the instrument panel for broken gauge(s),
meter(s) and Easy Checker
â„¢
indicators.
2. Replace if broken.
13. Checking headlight, hazard light,
and so on
1. Inspect the lights for broken bulbs and lenses.
2.
Replace if broken.
14. Checking seat belt and ROPS
1. Always
check the condition of the seat belt and
ROPS attaching hardware before operating the
tractor.
2. Replace if damaged.
15. Checking and cleaning of
electrical wiring and battery cables
WARNING
T
o avoid personal injury or death:
• A loose terminal or connector, or a damaged
wire may affect the performance of the electrical
components or cause short circuits. Leakage of
electricity could result in a fire hazard, a dead
battery or damage to electrical components.
• Replace the damaged wires or connections
promptly.
• If a fuse blows soon after replacement, do not
use a larger than recommended fuse or bypass
the fuse system.
• Many wiring connections are protected by
waterproof plugs. Plug and unplug these
connections carefully and make sure they are
sealed correctly after assembly.
• Accumulation of dust, chaff or spilled fuel
deposits around the battery, electrical wiring,
engine or exhaust system may cause a fire
hazard. Clean these areas before starting the
work.
To avoid the premature electrical
malfunctioning, do not apply high pressure
water directly to battery, wiring, connectors,
electrical components or instrument panel.
Inspect the following regularly
1.
Check the wiring for chafed or cracked insulation.
2. Check the wiring harness clamps. Replace if
necessary.
3. Check
the connectors and terminals for looseness,
contamination or overheated (discolored)
connections.
4. Check the instrument panel for correct operation of
the switches and gauges.
Consult your KUBOTA Dealer regarding maintenance,
diagnosis and repair
.
16. Checking movable parts
If any of the movable parts, such as levers and pedals,
are
not moving smoothly because of rust or sticky
material, do not attempt to force them into motion.
In the above case, remove the rust or the sticky
material and apply oil or grease to the relevant spot.
Otherwise, the machine may be damaged.
EVERY 50 HOURS
1. Lubricating grease fittings
Apply a small amount of multipurpose grease to the
following points every 50 hours.
If
you have been operating the machine in extremely
wet and muddy conditions, lubricate the grease fittings
more often.
ROPS model
(1) Grease fitting (brake pedal)
 PERIODIC SERVICE DAILY CHECK
116
LX2610,LX3310

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota LX3310 and is the answer not in the manual?

Kubota LX3310 Specifications

General IconGeneral
Engine TypeDiesel
Drive4WD
Cylinders3
Transmission TypeHydrostatic
Hydraulic System TypeOpen center
3-Point Hitch CategoryCategory I
TransmissionHydrostatic
Fuel Capacity8.5 gal
Displacement91.5 cu in
Lift Capacity at 24" behind lift point881 lbs (400 kg)
Length115.2 in (293 cm)
Height87.4 in (222 cm)

Related product manuals