Kubota LX3310 User Manual

5. Properly dispose of used oil.
Oil capacity 15 L (4.0 U.S.gals.)
(1) Oil inlet
(2)
Dipstick
(A) Oil level is acceptable within
this range
[LX2610/LX3310]
(1) Drain plug
(2)
Drain plugs
[LX2610SU]
(1) Drain plug
(2)
Drain plug (both sides)
IMPORTANT :
• If
the 3-point hitch can not be raised by
setting the hydraulic control lever to the UP
position after long term storage or when
changing the transmission oil, turn steering
wheel
to the right and left several times to
bleed air from the system.
• Do not operate the tractor immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent damage to the
transmission.
3. Replacing hydraulic oil filter
WARNING
T
o avoid personal injury or death:
• Be sure to stop the engine before changing the
oil filter cartridge.
• Allow the engine to cool down sufficiently; oil
can be hot and can burn.
1. Remove
the drain plugs at the bottom of the
transmission case and drain the oil completely into
the oil pan.
2. After draining reinstall the drain plugs.
[LX2610/LX3310]
(1) Drain plug
(2)
Drain plugs
[LX2610SU]
(1) Drain plug
(2)
Drain plug (both sides)
PERIODIC SERVICE EVERY 400 HOURS
128
LX2610,LX3310

Kubota LX3310 Specifications

General

Engine Type	Diesel
Drive	4WD
Cylinders	3
Transmission Type	Hydrostatic
Hydraulic System Type	Open center
3-Point Hitch Category	Category I
Transmission	Hydrostatic
Fuel Capacity	8.5 gal
Displacement	91.5 cu in
Lift Capacity at 24" behind lift point	881 lbs (400 kg)
Length	115.2 in (293 cm)
Height	87.4 in (222 cm)