EasyManuals Logo

Kubota LX3310 User Manual

Kubota LX3310
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
Forcing
oil through the relief valve for extended
periods will overheat the oil.
When using the tractor hydraulic system to
power the front loader, do not operate the boom
and bucket cylinders simultaneously.
NOTE :
To use the single-acting cylinder with the float
valve, connect this cylinder to the (C) port.
To extend a single-acting cylinder, pull the
remote control valve lever rearward. To retract a
cylinder, push it fully forward to the “FLOAT”
position. Do not hold it in the down position or
the transmission fluid may overheat.
3. Remote control valve coupler
WARNING
T
o avoid personal injury or death:
Stop the engine and relieve pressure before
connecting or disconnecting lines.
Do not use your hands to check for leaks.
Connecting
1.
Clean both couplers.
2. Remove dust plugs.
3. Insert the implement coupler into the tractor
hydraulic coupler.
4. Pull the implement coupler slightly to make sure
couplers are firmly connected.
Disconnecting
1. Lower
the implement to the ground to release
hydraulic pressure from the hoses.
2. Clean the couplers.
3. Relieve pressure by moving hydraulic control levers
with engine shut off. Pull the hose straight from the
hydraulic coupler to release it.
4. Clean oil and dust from the coupler, then replace
the dust plugs.
NOTE :
Your local KUBOTA Dealer can supply parts for
adapting couplers to hydraulic hoses.
 HYDRAULIC UNIT REMOTE HYDRAULIC CONTROL SYSTEM (IF EQUIPPED)
88
LX2610,LX3310

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota LX3310 and is the answer not in the manual?

Kubota LX3310 Specifications

General IconGeneral
Engine TypeDiesel
Drive4WD
Cylinders3
Transmission TypeHydrostatic
Hydraulic System TypeOpen center
3-Point Hitch CategoryCategory I
TransmissionHydrostatic
Fuel Capacity8.5 gal
Displacement91.5 cu in
Lift Capacity at 24" behind lift point881 lbs (400 kg)
Length115.2 in (293 cm)
Height87.4 in (222 cm)

Related product manuals