How to fix uneven stubble with KUHN Lawn Mower?
Uneven stubble on your KUHN Lawn Mower can occur if the knives are dull or broken, so replace them. Also, ensure the knives are installed correctly, with the arrow on the knife's upper face pointing in the disc's direction of rotation. Finally, check that the PTO speed is adequate; increase it to 540 min-1 or 1000 min-1 if it's too low.
What to do if soil builds up in front of the cutterbar on KUHN Lawn Mower?
Soil build up in front of the cutterbar on your KUHN Lawn Mower can be caused by too much cutterbar down pressure. Increase the accumulator pressure to resolve this. Very wet working conditions can also contribute; adjust the main frame height with regards to the ground in such conditions.
What to do if there is insufficient cutterbar ground clearance in "headland turn" position on KUHN Lawn Mower?
Insufficient cutterbar ground clearance in the "headland turn" position on your KUHN Lawn Mower can be due to an incorrect tractor lift linkage setting. Refer to the machine attachment instructions to resolve this. Also, if the leveling rod adjustment on the tractor 3-point lift is too long, shorten the leveling rods on the tractor's 3-point lift.
Why is there bad ground contour adaptation on my KUHN Lawn Mower?
Bad ground contour adaptation with your KUHN Lawn Mower may be due to an incorrect main frame setting. Adjust the main frame height with regards to the ground. Excessive ground speed can also cause this issue, so reduce your ground speed. Insufficient ground pressure may also be a factor; in this case, reduce the accumulator pressure.
Why is there excessive lateral oscillation in transport position on my KUHN Lawn Mower?
Excessive mowing-conditioning unit lateral oscillation in transport position on your KUHN Lawn Mower is caused by incorrect transport stop adjustment. To fix this, readjust the transport stop.
General| Brand | KUHN |
|---|---|
| Model | GMD802 Series |
| Category | Lawn Mower |
| Language | English |
To Next Page
