Power harrow
42
HR6004DR
Putting into service
Adjusting the side deflector
The vertical position of the deflector must be adjusted to:
- The working depth.
- The blade wear.
Loosen the 4 nuts (1).
Adjust side deflector (2) to the required position.
Tighten the 4 nuts (1).
The longitudinal (front-rear) position of the deflector anti-
ridging plate must be adapted to:
- The roller position and type.
Loosen the 2 nuts (1).
Set side deflector anti-ridging plate in the required
position.
Tighten the 2 nuts (1).
For safety reasons, it is not allowed to fold
the side deflectors over the trough.
Adjust both sides to the same setting.
The anti-ridging plates must be positioned
nearest the roller, but without interference.
Adjust both sides to the same setting.
To Next Page
Loading...