Power harrow
46
HR6004DR
Instructions for work
$Instructions for work
1. Putting the machine into work
position
From the transport position:
- Raise the tractor lift linkage to provide sufficient
ground clearance of working parts.
- Activate half-harrow lift cylinder control valves to
release locks.
- Pull on release cord.
- Activate half-harrow cylinder control valves to lower
the half-harrows in work position.
- Lower front loosening share:
• Insert and lock pin (1) in the lower hole underneath
pin (2).
• To adjust the front loosening share working depth,
use the various holes of the mounting bracket.
The machine is in working position.
Before placing the machine in working
position:
- Check that nobody is within the machine
pivoting area.
- If there is someone, make sure the
person moves away.
To Next Page
Loading...