Power harrow
44
HR6004DR
Instructions for transport
$Instructions for transport
1. Putting the machine into transport
position
From the working position:
- Lift the machine with the tractor's three point linkage.
- Activate half-harrow lift cylinders (1) until locks (2) are
fully engaged.
- Raise front loosening share:
Insert and lock pin (1) in the lower hole underneath pin
(2).
The machine is in transport position.
Before placing the machine into transport
position:
- Wait until the rotating parts have come
to a complete stop.
- Check that nobody is within the machine
pivoting area:
• If there is someone, make sure the
person moves away.
When optional equipment is used, follow
specific procedures mentioned in the related
section «Optional equipment».
Check that there is no interference with the
tractor when the machine is in the raised
position.
Never engage the tractor PTO drive when the
machine is in transport position.
To Next Page
Loading...