Maintenance and storage
Power harrow
HR6004DR
65
Intermediate PTO shaft 2
Every 250 hours or at the end of the season:
- Transmission tube:
• Slide the black collar.
• If necessary, rotate one rotor to access the grease
nipple (6).
• Slide the black collar back in place when lubrication
has been completed.
- U-joints (1).
• Remove gearbox protection (4) to access U-joint
greaser on lateral gearbox side.
- guide rings (3):
• Unlock and slide guards for easier greasing of the
PTO shaft u-joints and guiding bushes.
Each time the 2 half-PTO shafts are split:
- Transmission tube (The two grease nipples (2)).
Place the machine in working position.
Turn off the engine, remove ignition key and wait
until all moving parts have come to a complete
stop.
To access the 2 grease nipples (2) to grease.
During intensive use with tractors of
maximum authorized power, it is
recommended to grease at closer intervals
(Interval of 100 to 150 hours).
Repeat procedure on the second intermediate
PTO shaft 2.
To Next Page
Loading...