Why is the speed incorrect on my KUHN RPB?
If the speed displayed on your KUHN Control Unit is incorrect, it might be due to a faulty speed sensor or incorrect sensor adjustment. Verify the speed sensor and wiring function, replacing any worn or damaged parts with genuine KUHN parts immediately. Also, ensure that you carry out the calibration as described in the "Configuration" chapter.
What to do if the KUHN RPB Control Unit control box does not come on?
If your KUHN Control Unit's control box does not turn on and isn't controlling any functions, there could be a faulty electric power supply or the control box itself might be faulty. First, check the plug voltage (12V) and ensure the electrical power cable of the control box is properly connected, referring to the "Assembly and fitting" section. If the issue persists, contact your KUHN authorized dealer.
What to do if I get a flow alarm on my KUHN Control Unit?
If you are getting a flow alarm on your KUHN Control Unit, try reducing the pump flow and ground speed.
Why am I getting over or underdosage with my KUHN RPB Control Unit?
If you experience over or underdosage with your KUHN Control Unit, it could be due to an incorrect control box setting. Consult the relevant section in the "Configuration" chapter. If the problem persists, contact your KUHN authorized dealer.
What to do if I get a maximum pressure alarm on my KUHN RPB?
If you are getting a maximum pressure alarm on your KUHN Control Unit, check the type of nozzle being used and replace it if necessary. Additionally, try reducing the ground speed.
What to do if I get a minimum flow alarm on my KUHN RPB?
If you are getting a minimum flow alarm on your KUHN Control Unit, try increasing the pump flow and forward speed.
What should I do if I receive a minimum pressure alarm on my KUHN RPB?
To address a minimum pressure alarm on your KUHN Control Unit, increase the pump flow and forward speed.
General| Type | Control Unit |
|---|---|
| Model | RPB |
| Manufacturer | KUHN |
| Compatibility | KUHN Balers (specific models, check documentation) |
| Display | LCD screen |
| Buttons | Multiple buttons for function control and menu navigation |
To Next Page