Operating instructions
HiLite
®
power 3D
- 13 -
GB
DE
GB
FR
ES
IT
PT
NL
SE
DK
NO
FI
GR
9.2.3 Lamp reflector
Cleaning: Wipe the reflector down at least once a month with a soft, lint-free cloth to clean it.
DISCONNECT FROM MAINS
Risk of fatal injury!
Unplug the device before working on it.
NOTE
Dirt on the flash lamp will considerably reduce its service life.
Observe the following information:
When cleaning the lamp reflector with a cloth, do not touch the lamp with your fingers or spread any dirt over it.
Remove heavy dirt with a mild cleaning or rinsing agent.
9.2.4 Filter disc
Cleaning: Wipe both sides of the disc down at least once a week with a commercial glass cleaner.
NOTE
Only use the disc again if it is in perfect condition and if there are no streaks or other dirt on it.
9.2.5 Filter
Cleaning: Clean the filter if it becomes dirty because of compressed air. Do not perform this work in the building.
10 Maintenance / Repair
10.1 Maintenance
CAUTION
The device will only function properly if original spare parts are used.
Observe the following information:
Only use original spare parts.
ELECTRIC SHOCK
Caution electric shock!
Risk of fatal injury if instructions are not followed.
DISCONNECT FROM MAINS
Unplug the device before working on it.
The end user can replace the following parts:
Lamp reflector with flash lamp
Chip card
Filter disc
Light reflector
Filter
CAUTION
You do not have to disassemble the housing to do the work listed above!
If more comprehensive repairs are required, send the device to the manufacturer!
Please contact the relevant country office or regional Kulzer service partners!
See paragraph 15 Service.
NOTE
Before replace one of these parts, check whether its reduced performance is due to dirt. For the cleaning intervals
see paragraph 9 Cleaning.
To Next Page
Loading...