Operating instructions
HiLite
®
power 3D
- 15 -
GB
DE
GB
FR
ES
IT
PT
NL
SE
DK
NO
FI
GR
12 Disposal of old equipment according to WEEE
Electrical- and Electronic Equipment Act (ElektroG)
This Act sets out requirements for electrical and electronic equipment pursuant to directive 2012/19/EC issued by the European
Parliament and the European Council. Its main purpose is to prevent waste from electrical and electronic equipment and to
promote reuse, recycling and other forms of recovery to reduce both the volume of waste for disposal and the inclusion in waste
of harmful substances from electrical and electronic equipment.
For detailed information on professional disposal of disused old devices,
contact your dealer or Kulzer subsidiary in your country.
CAUTION
Marked equipment must not be brought to local waste disposal centres.
13 Technical Data
13.1 Mains connection
Value / Unit
Nominal voltage 100 V / 115 V / 230 V
Nominal frequency 50 / 60 Hz
Fuse 2 x T 6.3 A
Power consumption 325 VA
Dimensions (w x h x d) approx. 225 x 230 x 345 mm
Weight approx. 9.5 kg
Safety category Safety category I
On-duration 80%
Light source Xenon stroboscope flash bulb, flash frequency 20Hz
Emitted wavelength (main spectrum) 390 – 540 nm
13.2 Transport- and storage conditions
Temperature –15°C to +45°C (5°F to 113°F)
Relative air humidity less than 100% rel. moisture
13.3 Operating conditions
Temperature 5°C to 45°C (41°F to 113°F)
Air humidity 80% rel. humidity up 31°C (88°F)
50% rel. humidity up 45°C (113°F)
13.4 Rating plate
T 6,3 A / 250 V
2018-40011 130 0040
2018-02-0421
325
VA
100/115/230 V 50 / 60 Hz
66069514 HiLite power 3D 80% ED
Kulzer GmbH
Leipziger Str. 2, 63450 Hanau (Germany)
To Next Page
Loading...