46
TECHNICAL PASSPORT ENGLISH
Ceramic hob & Induction hob
When you have installed the
hob, make sure that:
 The power supply cable is not
accessible through cupboard doors or
drawers.
 There is adequate ow of fresh air
from outside the cabinetry to the base of
the hob.
 If the hob is installed above
a drawer or cupboard space,a thermal
protection barrier is installed below the
base of the hob.
 The isolating switch is easily ac-
cessible by the customer.
INSTALLATION
Cut out worktop to supplied dimensions
shown (Fig. 1) with suitable equipment.
Seal the cut edge of the worktop using
silicone or PTFE and allow to dry prior
to tting the hob.
Stretch out the supplied seal along the
underside edge of the hob, ensuring the
ends overlap.
Do not use adhesive to x the hob into
the worktop. Once the seal is tted
position the hob into the cutout in
the worktop. Apply gentle downwards
pressure onto the hob to push it into the
worktop ensuring a good seal around the
outer edge (Fig. 4).
Fig. 1
01
02
[04]x1
Fig. 2
[02]
Fig. 3 Fig. 4
To Next Page
Loading...
