Disk Mode
Load Function Dialog
13-20
Note that when loading into a specific bank (as opposed to loading as "Everything"), the object
ID's in the file are used as follows: The "bank" digit is ignored, and the remainder of the
number is used when the K2500 re-banks the object ID into the bank that you specify. For
instance, if you save Program 453 into a file, and load it back into the 300's bank, the K2500 will
use the number "53" when deciding upon a new object ID. If the 300's bank was previously
empty, and the load mode is Append, then the Program will end up with ID 353.
For loading as "Everything", the ID number for an object stored in a file is taken literally, and
not re-banked (except if Fill or OvFill mode is chosen, in which case the K2500 will use ID
numbers starting from 200.)
Here is an example that compares all of the above load modes.
EXAMPLE: Starting with the following objects already stored in the K2500 internal RAM:
Program|200|Existing|Prog1
Program|204|Existing|Prog2
Program|205|Existing|Prog3
Program|210|Existing|Prog4
Program|211|Existing|Prog5
Suppose you were to load file containing the following objects into the 200's bank:
Program|405|Electric|Piano|
Program|406|Stereo|EPiano||
Program|409|Weird|Piano||||
Program|410|Wild|Funk|Piano
Here is what these programs would end up with as ID numbers when loaded in, depending on
the load mode:
Name Append Fill Merge Overwrt OvFill
Electric|Piano| 206 201 205 205 200
Stereo|EPiano|| 207 202 206 206 201
Weird|Piano|||| 209 203 209 209 202
Wild|Funk|Piano 212 206 210 210 203
In the Merge case, the existing programs 205 and 210 would have been deleted. In the
Overwrite case, all of the existing programs in the 200's would have been deleted.
To Next Page
Loading...
Need help?
General
