Disk Mode
Macros
13-52
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Delete|macro|entries?|||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||Yes||||No||
If you answer Yes, the display returns to the Macro page and all of the previously selected
entries will be gone from the list. If you answer No, the display will return to the Modify
Macro Entries dialog.
Pressing Cancel in the Modify Macro Entries dialog will return to the Macro page with
everything that was selected still selected, but with no parameter changes made to any Macro
entries.
Here are the parameter values for Modify Macro Entries:
Once you have made the necessary changes to the in-memory Macro, you can go to the Save
Macro page to write selected (or all) entries to a new disk file (or replace over the original
Macro file you may have loaded in for editing.)
Executing the In-Memory Macro
You can load any group of files listed in the in-memory Macro. This is done using the Load
soft button on the Macro page:
Func:MACRO||||[Record]|||||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|1:\STRINGS.KRZ||||||||||||||||200:F:|||
*1:\PIANO.KRZ||||||||||||||||||300:F:|||
|1:\DRUMS.KRZ||||||||||||||||||400:F:|||
*1:\NOISE.AIF||||||||||||||||||500:F:|||
Select|Modify||Load||Pause|||Off|||Exit|
Parameter Values
Modify Drive,
Bank/Mode
Drive Floppy, SCSI 0, SCSI 1, SCSI 2, SCSI 3, SCSI 4, SCSI 5,
SCSI 6, SCSI 7, Unspecified, Library
Bank 000's, 100's, 200's, 300's, 400's, 500's, 600's, 700's, 800's,
900's, Everything
Mode Append,
Merge,
Fill,
Overwrite,
OvFill
To Next Page
Loading...
Need help?
General
