Disk Mode
Disk Utilities
13-60
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Use|default|directory|for|ATOMTOM.KRZ?||
(Path|=|\DRUMHITS\)|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Change||OK|||Cancel
Press OK to use the default.
Press Change if you want to select a different destination from the default shown. The K2500
will then display a directory selection dialog (described early in this chapter), and you can
select the move destination directory from there:
Dir:\||||||||||||Sel:0/15||||Index:|||4|
|||||||||||||||||BLOWFISH.KRZ||||||36K||
|||||||||||||||||COLORS||.KRZ|||||109K||
|Select|dest|dir:DRUMHITS||||(dir)||||||
|||||||||||||||||EARTHLNG.KRZ|||||144K||
|||||||||||||||||HANDCLAP.KRZ|||||645K||
Total:6846K||||||INDUSTRY||||(dir)||||||
|Root||Parent|Open||Current|SetDir|Exit|
The move operation begins when you press either Current or SetDir.
If the default destination directory is the same as the source directory, the K2500 will skip the
"Use default directory?" question and instead go right to the "Select dest dir:" dialog.
A good way to organize files into subdirectories, with a disk drive that was being used with
previous versions of K2500 software, is by using the Move command. First, create the
subdirectories you need, using the NewDir function. Then, use multiple file selection to select
the files to be grouped into a particular subdirectory. The files can be moved to their new
location in one operation.
For each file that is moved, you will see a confirmation message:
\ATOMTOM.KRZ|moved|to|||||||||||||||||||
\DRUMHITS\ATOMTOM.KRZ
Note the following:
• You can select multiple files for moving within a directory. However, you cannot move
files from more than one directory at a time. If you select any files and then switch to
another directory, the files you had chosen will be deselected.
• If you are moving a directory, you cannot move it in to a subdirectory of itself.
• If the source and destination directories are the same, the file will not be moved, and an
error message such as the one below is displayed. This would happen if you pressed
Current above.
• The same message will be displayed if there is a file in the destination directory with the
same name as the file to be moved.
File|\ATOMTOM.KRZ|not|moved.||||||||||||
To Next Page
Loading...
Need help?
General
