SHIFT
VOLUME
MIN MAX
Setup
This section contains information about setting up your instrument
and preparing to play. Please go through this section carefully before
turning the power on.
Power Supply
You can power the instrument either by batteries or by power adaptor.
Before you switch your instrument on, turn down the volume of
instrument and the connected audio equipment first.
Using Batteries
The instrument needs 6 pieces of AA (NO.5) or equivalent alkaline
batteries for power supply.
1. Open the battery compartment cover located on the bottom of the
instrument.
2. Insert the batteries, carefully follow the polarity markings on the
cabinet.
3. Replace the compartment cover, making sure that it locks firmly in
place.
Note:
1. Do not mix used and new batteries.
2. Always use same types of batteries.
3. Always remove the batteries from the instrument when it is not
being used for an extended period of time.
Using Power Adapter
1. Connect the adaptor to the power supply jack of this
instrument.
2. Plug the adaptor into an AC outlet.
3. Press the POWER SWITCH, the LCD screen is lit, which indicates
the instrument is powered on.
4. If you are ready to turn off the instrument, press the POWER
SWITCH again.
Note:
1. In standby mode, the instrument will automatically shut down in 30
minutes if it is not used. (Please refer to “Auto Power Off” for
details).
2. For your safety, please unplug the instrument when it is not in use
or during a thunderstorm.
Setting a Music Stand
A music stand is supplied with the instrument. You can easily attach it
by inserting it into the slots at the rear of the panel.
06
Open
VOLUME
MIN MAX
To Next Page
Loading...
